Filter
Top Products
Setup
Q-Wash 260-LED User Manual Rev. 05 -7-
DMX Linking
You may link the Q-Wash 260-LED to a DMX controller using a standard DMX serial
connection. If using other DMX compatible products with this product, it is possible to
control them individually with a single DMX controller.
DMX Modes
The Q-Wash 260-LED uses the standard DMX data connection for its Basic and Advanced
DMX modes. You will find information about these DMX modes in the Operation chapter
(configuration details), and the DMX Values section (individual channel values).
Master/Slave
Connectivity
The Master/Slave mode allows a Q-Wash 260-LED product to control one or more
products of the same model without a DMX controller. The controlling product becomes the
“master product” when running the Auto1, Auto2, or Custom programs.
You must configure the controlled (slave) products to operate in “SLAVE” mode from their
respective control panels. During the Master/Slave operation, the slave products will
operate in unison with the master product. .
If you are not familiar with the DMX standard, master/slave connectivity, or if you need
information about the DMX cables needed to link this product to a DMX controller, you may
download the document DMX Primer from the CHAUVET® website: www.chauvetpro.com.
DO NOT connect a DMX controller to the products operating in Master/Slave mode.
The DMX controller signals may interfere with the signals from the master unit.
The Operation chapter of this manual provides detailed instructions on how to configure
the Master and Slave units.