Filter
Top Products
Operation
-10- Q-Wash 260-LED User Manual Rev. 05
Master/Slave
The Master/Slave mode allows a group of Q-Wash 260-LED products (the slaves) to
simultaneously duplicate the output of another Q-Wash 260-LED (the master), whether
auto/custom or static modes, without a DMX controller.
1. Set the master unit:
a) Select a stand-alone mode, as indicated above.
2. Set each of the slave units:
a) Go to MENU > INTRO > RUN.
b) Select SLAVE.
Do not connect a DMX controller to the master or slave products.
The master unit should be the first unit in the DMX daisy chain.
Display Mode
This mode defines how the LCD’s backlight will work.
1. Go to MENU > INTRO > DISPLAY.
2. Select a display mode (60 CLOSE or BRIGHT).
When in the “60 CLOSE” setting, the LCD’s backlight will turn off after 60 s.
When in the “BRIGHT” setting, the LCD’s backlight will stay on.
Software Version
This option will show the installed software version.
1. Go to MENU > INTRO > INFO.
2. The display will show Edition.
3. Press <ENTER> to see the installed software version.
Keylock
This option enables or disables the LCD key.
1. Go to MENU > INTRO > KEYLOCK.
2. Select YES or NO.
When in the “YES” setting, the user will have to enter the password after 30 seconds
of control panel inactivity or each time he/she turns the product on.
The default (non-modifiable) password is
<UP>, <DOWN>, <UP>, <DOWN>, and <ENTER>.
Fan
You can select the fan operation mode, as follows:
1. Go to MENU > INTRO > FANS.
2. Select HIGH, NORMAL, LOW, or AUTO.
The product’s controller will force the fan to High if the product’s internal
temperature becomes too high, despite any manual or DMX setting.
Reset
This option allows you to reset all custom settings to their default values.
1. Go to MENU > INTRO > RESET.
2. Select YES or NO.