Filter
Top Products
Setup
-8- Q-Wash 260-LED User Manual Rev. 05
Mounting
Before mounting this product, read and follow the safety recommendations indicated in the
Safety Notes section (page 2 of this manual).
Orientation
Always mount this product in any safe position while making sure that there is adequate
room around it for ventilation, head motion, configuration, and maintenance.
Rigging
CHAUVET® recommends following the general guidelines below when mounting this
product.
When selecting an installation location, consider ease of access to the product for
operation, programming adjustments, and routine maintenance.
Make sure to mount this product away from any flammable material, as indicated in the
Safety Notes section or obstructions that may block the moving head.
Never mount the product in places where rain, high humidity, extreme temperature
changes, or restricted ventilation may affect it.
If hanging this product, make sure that the location where you are mounting it can
support its weight. Please see the Technical Specifications section of this manual for
the weight requirement of this product.
Procedure
The Q-Wash 260-LED comes with two omega brackets to which you can attach clamps.
You must supply your own clamps and make sure that they are capable of supporting the
weight of this product. You will have to use two mounting points per product. The omega
brackets also serve to anchor this product to a panel. For floor standing operation, this
product has built-in rubber feet.
ProductMounting
Diagram
SafetyCable(included)
Clamp(notincluded)
Omegabracket(included)
OverheadMounting
FloorStanding