Filter
Top Products
1-16
Cisco 8500 Series Wireless Controller Installation Guide
Chapter 1 Cisco 8500 Series Wireless Controller Installation Guide
Mounting the Cisco 8500 Series Wireless Controller in a Rack
Step 6 Attach the front of the slide rail and EIA latch to the front of the rack cabinet by installing a screw in the
bottom hole of the lower U; then, install another screw in the middle hole of the lower U to attach the
front of the slide rail to the front of the rack cabinet.
Note When you fasten the slides to the rack, ensure the screws are engaged but the flange can move slightly.
You will use a screwdriver to fully tighten them in Step 9.
Note Use 12-24 screws (not hex head M6 screws) on the front mounting bracket if you are installing this
system into a rack with round or square holes (i.e., not threaded holes).
Step 7 Use two screws to attach the rear of the slide rail to the rear of the rack cabinet in the upper and the
bottom holes of the lower U.
Repeat Step 3 through Step 7 to install the other slide rail into the rack.
Cap head
M6 screw
255170
Hex head
M6 screw
255171