Filter
Top Products
1-39
Cisco 8500 Series Wireless Controller Installation Guide
Chapter 1 Cisco 8500 Series Wireless Controller Installation Guide
Removing DC Power Supply from Controller
Removing DC Power Supply from Controller
To remove the DC power supply from the controller, complete the following steps:
Step 1 Turn off the controller and peripheral devices.
Step 2 Disconnect the DC power cable from the DC power source (turn off the circuit breaker).
Step 3 Remove the DC power cable from the rear of the power supply.
Step 4 Grasp the power supply handle.
Step 5 Press and hold the orange release latch to the left.
Step 6 Pull the power supply part of the way out of the bay.
Step 7 Release the release latch; then, support the power supply and pull it the rest of the way out of the bay.