Filter
Top Products
1-14
Cisco 8500 Series Wireless Controller Installation Guide
Chapter 1 Cisco 8500 Series Wireless Controller Installation Guide
Mounting the Cisco 8500 Series Wireless Controller in a Rack
Step 2 Use a screwdriver to install the cage bars or the clip nuts on the inside of the mounting rail, as required
for your rack, into the selected holes.
Step 3 The rail depth can be adjusted from 17 in (432 mm) to 31.25 in (794 mm). To adjust the depth, you can
loosen the nuts on the posts and slide the bracket until the distance between the front and rear slide rail
flanges matches the distance between the front and rear EIA rails of the rack cabinet. If you need further
adjustment, remove the nuts, move the bracket to the appropriate set of posts (A, B, C, and D) to obtain
the appropriate slide rail depth, then reinstall and tighten the nuts.
Front Rear
Upper U
(For 2 U
system)
Lower U
Clip or
cage nuts
Optional screw
to secure system
into the rack
255156
Cage
bars
Front Rear
Clip
nuts
Front Rear
255157