Filter
Top Products
assembly and alignment
ASSEMBLING LEG SET
Model 113.247210
From the loose parts bag find the following hard-.
ware:
ITEM DESCRIPTION QTY.
A Truss Head Bolts 1/4-20 x 1/2 .......... 40
B Lock Washers Ext. 1/4 ................. 40
C Hex Nuts 1/4-20 ....................... 40
D Leveling Feet .......................... 4
E Hex Nut 3/8-16 ........................ 8
From the loose parts find the following items:
ITEM DESCRIPTION QTY.
DE) Legs .................................. 4
EE Upper stiffeners ....................... 4
FF Lower stiffeners ....................... 4
Assemble the Leg Set as follows:
1. Attach the four (4) legs to the four (4) upper
stiffeners as shown. Three (3) bolts, washers,
and nuts are required to fasten each end of upper
stiffener to a leg. Hand tighten hex nuts.
2. Attach the four (4) lower stiffeners to the legs.
Two (2) bolts, washers and nuts are required to
hold each end of a lower stiffener in place. Hand
tighten hex nuts.
3. Attach four (4) leveling feet to bottom of each leg
as illustrated. Hand tighten hex nuts.
4. Put leg set in area intended for use of saw. With a
7/16-inch wrench or socket, securely tighten all
bolts. Adjust leveling feet.
WARNING: TO AVOID INJURY FROM UNEXPECT-
ED SAW OR WORK MOVEMENT, LEVELING FEET
MUST BE ADJUSTED SO THAT SAW DOES NOT
ROCK.
To Adjust leveling feet so the saw will sit properly:
a. Move saw to desired location.
b. With 9/16-inch wrench loosen bottom nut.
c. Back off top nut by hand.
d. Raise or lower foot by adjusting bottom nut
using 9/16-inch wrench.
e. Snug top nut against inside of leg by hand.
f. Adjust all four feet as necessary then tighten
all four bottom nuts using a 9/16-inch wrench.
LEG
\
.IEX NUTS
LEVELING FOOT
10