Filter
Top Products
INSTALLING THE SANDING BELT
1. Install the sanding belt and adjust tension to the
sanding position. (The letter"S" on the scale.)
2. Rotate the upper wheel by hand (clockwise) to
check the sanding belt tracking. Adjust tracking
if necessary. (Reference the blade tracking sec-
tion for tracking procedure.)
3. After tracking the sanding belt if the belt and the
platen do not align loosen the upper blade guide
support and slide the support in or out to align.
Then tighten set screws to hold support and
p{aten in place, It may also be necessary to adjust
the lower blade guide support to align the blade
guide with the sanding platen.
NOTE: A new sanding belt will stretch with use, so
check the tension often.
SANDING
BELT
OO
recommended accessories
Caster Set for Cabinet ................... 9-22254
Caster Set for Leg Set ........... 9-22222, 9-22221
Miter Gauge ............................ 9-29929
Hold-Down Clamp for Miter Gauge ....... 9-29928
Stop-Rods for Miter Gauge .............. 9-29924
Rip Fence .............................. 9-23402
Blades and Sanding Belts ............ See Catalog
Circle Cutting Attachment ............... 9-23411
Power Tool Know How Handbooks
Radial Saw (includes band saw section) .. 9-2917
Table Saw (includes band saw section) ... 9-2918
The recommended accessories listed here are cur-
rent and were available at the time this manual was
printed.
28