Filter
Top Products
location and function of controls
2 1
TENSION ADJUSTMENT KNOB WARNING LABEL
COVER
TILT
SCALE
4
BEVEL LOCK KNOB
1
WARNING 8
LABEL GUIDE BAR
lARD
BLADE
GUIDES
SLOT
GAGE
'ABLE
5 6
4 BLADE GUIDES
HANDWHEEL
ON-OFF SWITCH
7
5 6
GUIDES
7
BACK-UP BEARING
GETTING TO KNOW YOUR BAND SAW
1. Warning Labels.
2. Tensions adjustment knob -Tightening the knob
will increase the tension on the blade. Loosening
it will decrease the tension. Clockwise to tension,
counter clockwise to loosen.
3. Tension Scales- The fractional markings indicate
the correct blade tension for various widths of
blades. For example, when installing a 1/4-inch
wide blade, tighten the tension knob until the
pointer is pointing to the 1/4-inch marking.
4. Setting Bevel Angle - Pull the bevel lock knob
and adjust the band saw to the desired angle by
turning the handwheel, then push in the bevel
lock to secure.
5. Blade Guide Adjustment - The guides can be
adjusted in or out for various widths of blades
and locked in place by the set screws.
6. Lateral Blade Guide Adjustment - The guides
can be adjusted sideways and locked in position
by the capscrews to prevent the blade from
twisting during operation.
7. Blade Backup Bearing Adjustment - The thrust
bearings can be adjusted in or out for various
widths of blades and locked in place by the
setscrews.
,
Guide Bar Lock Knob - The upper blade guides
should just clear the workpiece while cutting.
Always adjust the guides before turning on the
band saw and lock the guide bar by tightening
the knob.
18