Filter
Top Products
7. Carefully position the motor so that the poly "V"
belt is around the motor pulley and the four
motor studs align with the slots in the motor
mount.
8, Push motor studs through and install the flanged
lock nuts to the three (3) motor studs with
spacers. Start the flanged nuts by hand only at
this time.
t II/
\
MOTOR MOUNT
9. Install the threaded stud through the hole in the
lower leg of the motor mount and over the motor
stud as shown.
THREADED STUD
MOTOR MOUNT
MOTOR MOUNT
10. Install a flanged lock nut onto this motor stud.
Tighten the flanged lock nuts, using a 3/8-inch
wrench, until almost tight.
NOTE: Do not over-tighten the flange nuts. The
motor should slide in the grooves to allow
tensioning of the belt.
FLANGED
11. Install the wing nut on the threaded stud.
12. Check that the poly "V" belt is on both pulleys
being sure that it is centered on each pulley.
13. Check that the pulleys are in line by sighting
down the side of the large pulley to see if it lines
up with the small pulley. If the pulleys are not in
line, loosen the set screw holding the pulley on
the motor shaft and position the pulley, A notch
in the small end of the motor support is provided
for access to the set screw and belt.
ACCESS
LLEY
FLANGED LOCK NUT WING NUT
14