Filter
Top Products
MOUNTSAWONWORKSURFACE(FIG.C)
1. Ifthelegsetwillnotbeused,thesawmustbe
properlysecuredtoasturdyworkbenchusingthe
fourmountingholesat thebaseofthesaw.
2. Thesurfaceofthetablewherethesawistobe
mountedmusthavea holelargeenoughtofacilitate
sawdust%Fthroughandremoval
& Squarethesawonthemountingsurfaceandmark
thelocationofthefour3/8in.mountingholes(1).
4. Drill3/8in.holeintothemountingsurface.
& Markan11in.square(2)centeredbetweenthefour
mountingholes(1).
& Cutoutandremovethesquare.
7. Thisopeningwillallowsawdusttofal!throughthe
sawbase.
& Placethesawontheworksurface,andalignthe
mountingholesofthesawwiththosedrilledthrough
thesurface.
9. Fastenthesawtotheworksurface.
IA WARNINGI
Do not operate this machine on the floor. This is
very dangerous and may cause serious injury.
Fig. C
IA WARNINGI
Failure to provide the sawdust fall-through hole for
use of the saw when mounted to a work surface and
not the stand will cause sawdust to build up in the
motor area, which may result in fire or cause motor
damage.
IA WARNINGI
Always keep your work area clean, uncluttered and
well lit.
INSTALLING THE DUST BAG (FIG. D)
[_ WARNING]
Do not use this saw to cut and/or sand metals. The
hot chips or sparks may ignite sawdust or the bag
material
Place the dust bag around the neck of the dust
chute and tie the dust bag pulling the string tight
and secure with the spring4oaded tie clip.
Fig. D
BLADE RNSJNG HANDWHEEL (FIG. E, F)
1. Attach the up .- down handwheel (1) to the elevation
rod (2) at the front of the saw. Make sure the slots (3)
in the hub of the handwhee! (1) engage with the
pins (4).
2. Attach and tighten the dome nut (5 - Fig. F).
Fig. E
BLADE TILTING HANDWHEEL (FIG. F)
1. Attach the bevel 0° .- 45° handwheel (6) to the blade
tilting rod on the right side of the saw in the same
manner as above.
2. Attach and tighten the handwhee! dome nut (5).
Fig. F
11