Filter
Top Products
Attachauxiliaryfencetoripfencewithtwo"C"clamps.
(Fig.dd)
Fig.JJ
DADO CUTS (FIG. KK)
IAWARNINGn
a. Only Stackabledado blades can be used on this
SaW.
b. DO NOT use Adjustable or Wobble type dadoes.
c. Maximum dado cut width is 1/2in.
1. A dado table insert must be purchased separately
for this saw to accept a dado blade. Remove
saw blade and blade guard for dado cuts ONLY.
Reinstall and realign blade guard for all through
sawing operations. Install a dado not exceeding 6
in. in diameter and 1/2in. in width
2. install the dado table insert making sure the
rear of the insert is flush with the table. A rubber
adjusting spacer is provided under the rear of the
insert for this purpose.
3. instruction for operating the dado is packed with
the separately purchased dado set.
4. The arbor (1) on this saw restricts the maximum
width of the cut to 1/=in.
5. tt is not necessary to install the outside
flange (2) before threading on the arbour nut (3)
for maximum 1/=in. dado cuts. Make sure that the
arbor nut (3) is tight, and that st least one thread
of the arbor sticks out past the nut.
6. Use only the correct number of round outside
blades and inside chippers as shown in the dado
set's instruction manual. Blade/chippers must
not exceed 1/2in. total in width.
7. Check saw to ensure that the dado will not strike
the housing, insert, or motor when in operation.
[,_ WARNING 1
For your own safety, always replace the blade, blade
guard assembly, and btade insert when you are
finished with the dado operation. You must atso
realign the blade guard assembly.
Fig. KK
'l
i j2
J
_J
"_ 3
{
21