Filter
Top Products
Page 10
© 2000-2005 Router Technologies
All Rights Reserved
Subbase mounting holes
Router table fence reference line
Note: Cross lines for locating and drilling holes are accurate. The illustration of subbase may vary
slightly in size and design, but is accurate enough for cutting the rubber spacer if required.
Refer to pages 4.5.6. before using template
Additional Templates Available on Website
Craftsman
Use this 6" scale to check accuracy when copied
Drill .500" hole
through router
table insert plate
install #30 dust cover insert
into .500" hole and press flush
with top of insert plate
Router Raizer Access Hole
NOTE: This router requires a 3/4" pocket or use of 8" X 8"
black rubber spacer for router table installation. Pages 4 & 5
Router Raizer Access Hole
3/4" reference circle for drilling the
routers original subbase only. Table
mounted, drill 1/2" hole in table top.
.500" reference circle
for drilling table top or
insert plate.
Craftsman
NOTE: This hole must be drilled 1/2" or .500"
for #30 dust cover insert to fit properly.
1/2" = .500
Router table mounting holes