Filter
Top Products
15
Fig. 50
Fig. 51
Fig. 52
Fig. 53
ADJUSTING FENCE PARALLEL
TO MITER GAGE SLOTS
The fence (A) Fig. 50, should be adjusted so it is parallel
to miter gage slots (B). To check and adjust, move the
fence (A) until the bottom front edge of the fence is in line
with the edge of the miter gage slot as shown, and push
down on fence clamping lever (C). Check to see if the
fence is parallel to the miter gage slot the entire length of
the table. If the rear of the fence must be moved, slightly
tighten or loosen one of the adjustment plugs (D) or (E)
Fig. 50, using the arbor wrench or a 7/8" wrench, until the
fence is parallel with the miter gage slot. IMPORTANT:
DO NOT OVER-TIGHTEN PLUGS (D) AND (E) FIG. 50.
VERY LITTLE MOVEMENT OF THESE PLUGS IS
NECESSARY WHEN ADJUSTING THE FENCE
PARALLEL WITH THE MITER GAGE SLOT.
ADJUSTING FENCE 90
DEGREES TO TABLE
The fence must be adjusted so that the face of fence (A)
Fig. 51, is 90 degrees to the table. To check if the fence
is 90 degrees to the table, place a square (B) on the table
with one end of the square against the fence, as shown.
If an adjustment is necessary, tighten or loosen one of
two screws (C) or (D) until the fence is 90 degrees to the
table.
IMPORTANT: VERY LITTLE MOVEMENT OF THESE
SCREWS (C) AND (D) IS NECESSARY TO MAKE THIS
ADJUSTMENT.
ADJUSTING CLAMPING
ACTION OF FENCE
LOCKING HANDLE
When the fence locking handle (A) is pushed to the down
position, as shown in Fig. 52, the fence body (B) should
be completely clamped to the guide rail. If the fence body
(B) is not completely clamped to the guide rail when the
handle (A) is in the position shown in Fig. 52, lift up on
locking handle (A) Fig. 53, and slightly tighten two
adjustment plugs (C) using the arbor wrench or 7/8"
wrench. Adjustment plugs (C) should be tightened an
equal amount. Check to see if the fence body (B) is
completely fastened to the rail by pushing down on
locking lever (A). Adjust further if necessary.
IMPORTANT: AFTER ADJUSTING THE CLAMPING
ACTION OF THE FENCE LOCKING HANDLE, CHECK
TO SEE IF THE FENCE IS PARALLEL TO THE MITER
GAGE SLOT AND ADJUST IF NECESSARY.
A
B
C
D
E
B
A
D
C
B
A
C
C
A
B
C
C