Delta 36-902 Saw User Manual


 
7
Fig. 17
S
13. Using a straight edge (S) Fig. 17, make certain the
Unifence table surface is level with the saw table by
adjusting two leveling screws located on the bottom of
table legs and adjusting angle brackets (B) Fig. 13, use
a level, side to side and front to back to make sure the
table is level. IMPORTANT: Front edge of Unifence table
must be flush with or slightly behind front edge of saw
table.
Fig. 16
12. Assemble the table (A) to the two brackets (J) on
the rear table support (K) Fig. 16, using two #8x7/8"
screws.
A
J
K
ASSEMBLING UNIFENCE
GUIDE RAIL TO A SAW
WITH A LEFT SIDE SHEET
METAL EXTENSION WING
When mounting a 36-902 Unifence to a saw with a left
side sheet metal wing, if the ON/OFF switch is mounted
to the extension wing proceed with step #1 if not
proceed to step #2.
1. Remove the screw (A) Fig. 18 that attaches the
ON/OFF switch to the sheet metal wing. Insert a 3/8-
16x1¼" hex head screw through the sheet metal wing
and the ON/OFF switch bracket and place a 3/8" washer
onto the screw, and thread a 3/8-16 hex nut onto the
bolt, do not tighten the nut at this time. NOTE: LEAVE
THE HEX HEAD BOLT EXTENDED OUT THE FRONT
OF THE SHEET METAL WING, THE GUIDE RAIL WILL
BE ATTACHED TO THE END OF THE HEX HEAD
SCREW.
2. Insert a 3/8-16x1¼" hex head screw (A) Fig. 19
through the sheet metal wing and place a 3/8" washer
onto the screw, and thread a 3/8-16 hex nut onto the
bolt, do not tighten the nut at this time. NOTE: LEAVE
THE HEX HEAD BOLT EXTENDED OUT THE FRONT
OF THE SHEET METAL WING, THE GUIDE RAIL WILL
BE ATTACHED TO THE END OF THE HEX HEAD
SCREW.
Fig. 18
A
Fig. 19
A