Delta 36-902 Saw User Manual


 
2
INTRODUCTION
The model 36-902, 30" capacity Unifence
Saw Guide can be assembled to the, Contractors Saw and Unisaw, in
addition to other makes of table saws. The 36-902 Unifence Saw Guide includes the fence, carriage assembly, front
guide rail, table frame and legs. The accessory 36-893 table for the 36-902 30" Unifence, is not included and must be
ordered separately or a similar table must be constructed by following the instructions in this manual.
UNPACKING
Carefully unpack the Unifence and all loose items from the shipping cartons.
Fig. 1
1. Rail
2. Front Table Support Bracket (1)
3. Fence
4. Unifence Body
5. Table leg Support Bracket
6. Table Adapter Plate
7. Table Leg (2)
8. Rear table support bracket
9. 1/4-20x2" Flip stop bolt
10. Flip stop bracket
11. 5/16-18x1" Hex head bolt
12. Flip stop
13. Flip stop knob
14. 1/4-20 Nut
15. Flip stop fiber washer (2)
16. Unifence cursor
17. Angle bracket (5)
If you purchased the Unifence without the table, a table must be constructed, as follows:
1. A 32" long by 27" wide table is constructed using 3/4" material by following the dimensions shown in Fig. 2.
2. Three undercuts must also be made on the bottom left end of the table. The location and size of the undercuts are
shown in detail in Figs. 2 and 3.
3. IMPORTANT: For maximum ease when sliding the fence across the table we suggest that the top of the table be
covered with a veneer.
CONSTRUCTING UNIFENCE TABLE AND SHELF
1
3
2
4
5
6
7
9
10
11
12
13
14
15
8
14
15
11
10
9
13
12
16
17