Filter
Top Products
9
Fig. 9
Fig. 10
Fig. 11
6. Locate pinion knob (N) Fig. 9, spring (O), and special
screw (P).
7. Position pinion knob (N) Fig. 10, onto the back of
saw so that the teeth on the pinion knob (N) engage the
teeth on the trunnion (R). Fasten in place with special
screw (P) and spring using the supplied 4mm wrench.
8. Fasten pointer (S) Fig. 11, to the back of band saw
using the M5x.8x10mm pan head screw (T).
9. Place locking handle (F) Fig. 4, onto stud (G). Place
spring (E) Fig. 4, inside hole of lock handle and fasten in
place with screw (D) as shown in Fig. 11. NOTE: Handle
(F) is spring-loaded and can be repositioned on the stud
by pulling out the handle and repositioning it on the nut.
10. Insert M6x1x30mm screw (W) Fig. 12, down through
hole in table, as shown, and place an M6 flat washer (Z)
onto the M6x1x30mm screw (W) and thread the M6x1
wing nut (X) onto screw (W) and tighten securely.
N
O
P
R
N
P
F
S
T
D
Fig. 12
W
Z
X