Filter
Top Products
10
Fig. 9
9. Insert table (H) Fig. 9, into hole in table bracket as
shown.
Fig. 10
10. Thread table locking lever (J) Fig. 10, into hole in
front of table bracket as shown.
Fig. 11
Fig. 12
11. Place the drill press head (K) Fig. 11, onto the
column as far as it will go. Align head (K) Fig. 12, with
table (L) Fig. 12, and base (M) Fig. 12, and tighten the
two head locking screws (N) Fig. 11 with the 5mm
wrench supplied.
12. IMPORTANT: Make certain the tapered hole in the
bottom of spindle (T) Fig. 13, and the taper on spindle
adapter (U) are clean and free of any grease, lacquer or
rust preventive coatings. NOTE: If necessary, household
oven cleaner can effectively remove these coatings from
the spindle and spindle adapter; however, carefully follow
the manufacturer’s safety rules regarding its use.
13. Push spindle adapter (U) Fig. 13, up into spindle (T)
making certain the tang (V) engages the mating slot inside
spindle (T).
Fig. 13
T
U
V
H
J
K
N
K
L
M