Filter
Top Products
11
Fig. 14
14. IMPORTANT: Make certain the spindle taper (O) Fig.
14, and tapered hole in chuck (P) are clean and free of
any grease, lacquer or rust preventive coatings. NOTE:
Household oven cleaner can effectively remove any sub-
stance from the chuck; however, carefully follow the
manufacturer's safety rules concerning its use.
15. IMPORTANT: OPEN THE CHUCK JAWS AS WIDE
AS POSSIBLE MAKING SURE THE CHUCK JAWS
ARE INSIDE THE CHUCK.
16. Holding chuck on taper of spindle, tap with a soft tip
hammer (Q) or a block of wood and hammer to set
chuck, as shown in Fig. 15.
To avoid damage to the chuck, NEVER
drive the chuck onto the spindle with a metal hammer.
Fig. 15
Fig. 16
17. Thread the three pinion shaft handles (R) into the
three holes located in the pinion shaft hub (S), as shown
in Fig. 16.
O
P
Q
R
R
S