Filter
Top Products
13
OPERATING CONTROLS AND ADJUSTMENTS
STARTING AND STOPPING
DRILL PRESS
The switch (A) Fig. 20, is located on the front of the drill
press head. To turn the drill press “ON” move the switch
up to the “ON” position. To turn the drill press “OFF”
move the switch down to the “OFF” position.
Fig. 20
A
LOCKING SWITCH IN
THE “OFF” POSITION
IMPORTANT: When the machine is not in use, the
switch should be locked in the “OFF” position to prevent
unauthorized use. This can be done by grasping the
switch toggle (B) and pulling it out of the switch, as
shown in Fig. 21. With the switch toggle (B) removed,
the switch will not operate. However, should the switch
toggle be removed while the drill press is operating, the
switch can be turned “OFF” once, but cannot be
restarted without inserting the switch toggle (B).
Fig. 21
B
FLEXIBLE LAMP
The flexible lamp operates independently of the drill
press. To turn the lamp “ON” and “OFF”, rotate switch
(A) Fig. 22.
To reduce the risk of fire, use 40 watt or
less, 120 volt, reflector track type light bulb (not
supplied). A standard household light bulb should not be
used. The reflector track type light bulb should not
extend below the lamp shade.
Fig. 22
A
TABLE ADJUSTMENTS
1. The table can be raised or lowered on the drill press
column by loosening the table clamp (A) Fig. 23, and
turning the table raising and lowering handle (B). After
the table is at the desired height, tighten clamp (A) Fig.
23. NOTE: Final positioning of the drill press table
should always be from the bottom to the up position.
2. The table can be rotated 360 degrees by loosening
clamp (H) Fig. 23, rotate table to desired position and
tighten clamp (H).
G
A
B
H
Fig. 23