Filter
Top Products
English
4
DW7080
LOCKNUTS
END PLATE
DW7051
KNOBS
BOTTOM HOLE
(USE IF ON
RIGHT SIDE)
BRACKET
TOP HOLE
(USE IF ON
LEFT SIDE)
DW7082
DW7084
Optional Accessories
The following accessories, designed for your saw, may be helpful. In some cases, other
locally obtained work supports, length stops, clamps, etc., may be more appropriate. Use
care in selecting and using accessories.
Extension, Work Support: DW7080
Used to support long overhanging workpieces, the work support is user assembled.
Your saw table is designed to accept two work supports; one on each side.
Adjustable Length Stop: DW7051
Requires the use of one work support. It is used to make repetitive cuts of the same
length from 0 to 42" (1.06 m).
Clamp: DW7082
Used for firmly clamping workpiece to the saw fence for precision cutting.
Crown Molding Fence: DW7084
Used for precision cutting of crown molding.
Laser Guide System: DW7187
Powered by the saw, the bright laser line delivers enhanced visibility in low and high
light locations. Easy to install.
Miter Saw Replacement Kerf Plate: DW7055
This durable plastic uncut plate limits blade tear out.
SAW BLADES: ALWAYS USE 10" (254 mm) SAW BLADES WITH 5/8" (16 mm) ARBOR
HOLES. SPEED RATING MUST BE AT LEAST 5500 RPM. Never use a smaller diam-
eter blade. It will not be guarded properly. Use crosscut blades only! Do not use blades
designed for ripping, combination blades or blades with hook angles in excess of 5˚.
DEWALT BLADE
RANGE
NO. OF
TEETH
BLADE DESC. APPLICATION TYPE OF CUT
Series 20
Construction
40
Thin Kerf
Yellow Rim Coating
Gen. Purpose
(Trim, Decking,
Framing)
Smooth,
Splinter Free
Series 20
Construction
60
Thin Kerf
Yellow Rim Coating
Fine Trim Molding
Very Smooth,
Splinter Free
Series 40
Woodworking
40
Laser Cut Body
Large Carbide
Teeth
Gen. Purpose
(Trim, Decking,
Framing)
Smooth, Splinter
Free
Series 40
Woodworking
60
Laser Cut Body
Large Carbide
Teeth
Fine Trim,
Molding
Very Smooth,
Splinter Free
Series 40
Woodworking
80
Laser Cut Body
Large Carbide
Teeth
Fine Trim Molding
Decorative
Hardwood &
Plywood
Ultra Smooth,
Splinter Free
Series 40
Woodworking
80
Laser Cut Body
Large Carbide
Teeth, Special
Tooth Geometry
Melamines,
Veneers,
Laminates
Ultra Smooth
Chip/Splinter
Free
Series 40
Woodworking
60
Laser Cut Body
Special Tooth
Geometry
Plastics and other
solid surface
materials
Very Smooth
Chip Free
Series 40
Woodworking
80
Laser Cut Body
Special Tooth
Geometry
Non-ferrous
metals (aluminum,
copper, brass,
etc.)
Very Smooth
Burr Free
DW7187