Filter
Top Products
10
ATTACHING THE MOTOR TO THE MOTOR BRACKET
1. Position the motor (A) Fig. 5 on the motor brackets (B). Align the holes in the motor with the holes in the motor
bracket.
2. Insert a 5/16-18 x 3/4" carriage head bolt through the hole in the motor bracket and the hole in the motor.
3. Thread a 5/16-18 hex nut on to the bolt.
NOTE: Hand-tighten the hardware for future adjustment.
4. Repeat this process for the three remaining holes in the motor and motor bracket.
5. Place the stand upright (Fig. 6).
A
B
B
ATTACHING THE TOP PLATE TO THE STAND
1. Place the top plate (A) Fig. 7 on the top of the stand
(B).
NOTE: Place the switch cord (F) Fig. 7 through the
slotted hole (G) in the top plate (A) and insert a plastic
bushing (H) in the slotted hole (G).
2. Align the eight holes in the stand and top (6 in the
top and 2 on the side).
4. Insert a 5/16-18 x 3/4" carriage head bolt through
the top plate and the stand. Thread a 5/16-18 hex
nut on to the bolt.
5. Repeat this process for the seven remaining holes.
NOTE: Make sure the door opening is at least 13" wide
before you tighten the screws.
A
B
G
H
F
Fig. 5 Fig. 6
Fig. 7
NOTE: If your machine comes with an LVC starter box, refer to the enclosed supplemental instruction sheet for
mounting that equipment. Then follow these instructions: