Filter
Top Products
18
OPERATION
STARTING AND STOPPING THE SAW
1. The on/off switch is located on the left side of the
machine. To turn the machine “ON”, push the green
start button (A) Fig. 38.
2. To turn the machine “OFF”, push the red stop
button.
Make sure that the switch is in the "OFF"
position before plugging in the power cord. In the event
of a power failure, move the switch to the "OFF" position.
An accidental start-up can cause injury.
LOCKING SWITCH IN THE “OFF” POSITION
IMPORTANT: When the tool is not in use, the switch
should be locked in the “OFF” position to prevent
unauthorized use, using a padlock (C) Fig. 39 with a
3/16" diameter shackle.
A
B
C
TILTING THE TABLE
1. You can tilt the band saw table 45° to the right and
9° to the left. To tilt the table to the right, loosen the
two clamp handles (A) Fig. 40, tilt the table to the
desired angle. Tighten the locking handles (A) Fig.
40.
2. To tilt the table to the left, loosen the two locking
handles (A) Fig. 40 and tilt the table to the right.
Rotate the table stop (B) Fig. 41 all the way to
the right. Tilt the table to the left. Tighten the two
locking handles (A) Fig. 40.
NOTE: Use the scale (C) Fig. 41 to select the angle of
tilt, both right and left.
Disconnect the machine from the power source!
C
A
C
Fig. 38
Fig. 39
Fig. 40
Fig. 41
OPERATIONAL CONTROLS AND ADJUSTMENTS