Filter
Top Products
15
ATTACHING THE TABLE TO THE SAW
1. Insert the two table studs (A) Fig. 24 on the bottom
of the table into the two holes in the trunnion
assemblies (B).
NOTE: Face the slot (C) Fig. 24 in the front of the table
toward the front of the saw.
2. Thread a 7/16" jam nut (C) Fig. 25 on each table
stud and tighten securely.
3. Place a table handle (H) on each stud (Fig. 26).
NOTE: Position the table handles as illustrated in Fig.
26.
4. Thread a 7/16" locknut (D) Fig. 27 on each stud.
Tighten each locknut up to the table handle, then
loosen them 1/2 of a turn.
C
B
A
C
H
Fig. 24
Fig. 25
Fig. 26
Fig. 27
A