Filter
Top Products
Supplemental Owner’s Manual 13
Setting the Bevel Angle
The standard bevel range of the TS 55 REQ is between 0˚
and 45˚. However, an extended range is also available from
-1˚ to 47˚. The extended range is available by pulling out
on the limit release knob.
Bevel
Guage
Index
Pointer
Front
Thumbscrew
1. Loosen the front and rear bevel thumbscrews.
2. Tilt the saw until the index pointer is aligned with the
desired angle. To go above or below the normal limit
stops, pull out slightly on the limit release knob.
3. Retighten both bevel thumbscrews.
Rear
Thumbscrew
Limit
Release
Setting the Motor Speed
The TS55 has electronic speed control with soft-start
circuitry. The electronic controller will maintain the motor
speed even as the load changes. The speed control is
innitely variable from 2000 to 5200 RPM. The optimal
speed of the saw is predominately determined by the type
of material being cut.
Turn the speed control dial to the number shown in the table
below.
Material Speed
Soft wood products and veneer plywoods 6
Hardwood products 3-6
Plastic laminate countertops 6
Hard plastics 3-5
Soft plastics 1-4
Plaster and cementitious hardboard 1-3
Aluminum 4-6
Speed
Control