Filter
Top Products
14 TS 55 REQ
Using the Limit Stop
The limit stop serves two purposes: it controls the saw’s
starting position and prevents a kickback during a plunge
cut. The leading edge of the limit stop prevents the saw
from lifting up at the beginning of a plunge cut. This is what
prevents kickback during a plunging operation. Refer to
“Plunge Cutting” on page 18 for more information.
1. Slide the limit stop onto the T-slot of the guide rail
behind the saw, and with the embossed arrow pointing
toward the saw.
2. Position the stop behind the starting position of the saw.
► When the blade is at full-depth, the limit stop is 3¾
inches behind the start of the cut.
► When the blade is less than full depth, the distance
between the blade (cut) and the limit stop will be
greater.
► For best results, you should always verify the blade’s
cutting position before staring the cut.
3. Tighten the thumbscrew on the limit stop.
Guide Rail
T-Slot
Back of
Saw
Limit
Stop
Clamping
Thumbscrew
Using Dust Extraction
The TS55 can be used with or without a dust extraction
system. The chip diverter swivels to direct the sawdust away
from the work area when a dust extraction system is not
used.
For best results, however, a dust extraction system (such
as the Festool CT 22 shown below) should be used. Festool
dust extractors have the added features of variable speed,
and sensing when the saw is turned on. The vacuum will
automatically start when the saw is turned on, and will
remain running for a couple of seconds after the saw turns
off to clear the remaining dust.
Saw’s
Power Cord
Power Switch
Set to Auto
1. Insert the extractor hose on to the chip diverter.
► The 27mm Festool hose ts inside the diverter, and the
36mm Festool hose ts over the diverter.
► The diverter ID is 35mm (1⅜”), and the OD is 39mm
(1
9
⁄
16
”).
2. Plug the TS 55 power cord into the auxiliary outlet on the
extractor (if so equipped).
3. Set the power switch on the extractor to “Auto.” (The
auxiliary power outlet is active only when the switch is
set to Auto.)
27mm
Vac Hose