Filter
Top Products
24 TS 55 REQ
Troubleshooting
Symptom Possible Causes
Motor does not start
► Check that the cord is properly plugged into an outlet.
► Make sure the Plug-it connector is properly inserted and fully tightened.
► Make sure the outlet has power. Check the circuit breaker or try another outlet.
► If used with a Festool dust extractor, make sure the selector switch is pointing to “Auto”.
The auxiliary outlet on the dust extractor has power only when the selector is at Auto.
► Inspect the power cord (including extension cords) for damage or missing prongs.
► The motor brushes may have worn and need replacement.
e saw makes a
“Growling” sound when
it is rst turned on or
idling.
► This is normal operation. Refer to page 15 for more information.
e saw makes wavy
cuts
► Make sure the guide rail gib cams are properly adjusted.
► Inspect the blade for damage.
► Make sure the sole plate is not rocking on the guide rail.
► Keep the blade depth consistent during the cut; don’t raise and lower the blade.
► Forcing an ATB-type blade into the cut too fast can cause the blade to deect.
Saw cuts are burning
► Make sure to use the correct blade for the material.
► Make sure the blade is sharp.
► Make sure the blade is installed correctly (not turning backward).
► Reduce the motor speed.
► If possible, increase the blade depth.
► Increase your feed speed.
Excessive chipping on
the lower edge of the cut
► Make sure to use the correct blade for the type of material and type of cut.
► A very shallow blade depth can cause chipping on the underside if the teeth are barely
protruding below the surface. Increase the blade depth.
► The blade toe-in may be incorrect. Refer to page 22 for more information.
Excessive chipping on
the top edge of the cut
► Make sure to use the correct blade for the type of material and type of cut.
► Inspect the splinter guard. Make sure it is ush with the cut line for its entire length.
► Materials prone to splintering may splinter more if the blade is set too deep.
e sawblade fails to
retract aer a cutting
operation
► The saw requires immediate service, and should be removed from operation. Contact
Festool or your authorized Festool service provider.