Filter
Top Products
12
2. Using a 13mm spanner
(not supplied) loosen the
hex bolt on the riving knife
clamp (fig R) and insert
the riving knife between
the metal plate and the
clamp block (fig S).
3. Loosen the blade lock (24)
by lifting it up (fig T)
and turn the blade height
adjustment handle (20)
to raise the blade to its
highest position (fig U).
4.
Tighten the blade lock (24)
by pushing it back down
towards the table saw.
5. Adjust the height of the
riving knife so that the
gap between the knife
and the teeth of the blade
is even along the curve of
the blade and is not more
than 5mm.
6. Tighten the hex bolt to
secure the riving knife
in place.
7. Replace the table insert (13).
Fitting the blade guard
1. Remove the nut, screw
and 2 washers from the
blade guard.
2. Fit the blade guard onto
the top of the riving knife
ensuring that the slot in
the blade guard lines up
with the slot in the
riving knife.
3. Fit one flat washer onto the screw and place the
screw through the blade guard, riving knife and
blade guard again.
4. Fit the second flat washer
onto the end of the screw
followed by the nut.
5. Tighten the nut to
secure the blade guard in
position (Fig V) but do
not overtighten as this will
prevent the blade guard
from moving up and down
freely as the workpiece
passes below it.
Using the mitre gauge holder
1. The table saw features a mitre gauge holder on the
right hand side of the housing.
2. Slide the mitre gauge into the holder until it clicks into
place and is secure in the holder (fig W).
3. To remove the miter gauge
depress and hold both
latches on the holder and
pull out the mitre gauge.
Using the push stick holder
1. The table saw features
a push stick holder on
the right hand side of
the housing.
2. To insert the push stick place the tip of the push stick
into the bracket on the right hand side.
3. Lower the handle and rest it on the bracket on the left
hand side (Fig W).
S
T
U
R
V
W