Filter
Top Products
18
7. Take off the outer flange
and remove it and the
saw blade
(fig q).
8. Carefully clean the saw
blade flanges before
fitting the new blade.
9. Insert and secure the saw
blade in reverse order.
Caution. Take note of the
direction of blade rotation. The cutting edge of the teeth
must point in the running direction, i.e. forward (refer to
the arrow on the saw blade).
10. Re-fit and re-set the riving knife and the saw blade guard.
11.
Before using the saw again, check that all safety
devices are in good working order.
Important. After replacing the saw blade, make sure the
saw blade runs freely by turning the blade by hand.
12. Plug the machine into a mains socket and run the saw
at no load before using it to cut any materials.
Changing the
batteries of the
laser generator
Warning. Switch off the
machine and remove the
mains power plug before
carrying out any adjustments,
maintenance work or blade
changes.
1. Set the height of the
blade to its maximum.
2. Remove the blade guard
(19).
3.
Loosen the two screws
(12) at the top of the
laser assembly (fig r),
turn the securing tabs to
the side and remove the
laser battery cover (fig s).
Take out the two batteries.
4. Replace both batteries
with the same type
(or equivalent), taking
care to insert them the
same way round as the
old batteries (fig t).
5. Replace the battery cover.
6. Check and if necessary, adjust the laser line.
Maintenance
Warning. Always ensure that the tool is switched off and
the plug is removed from the power point before making
and adjustments or maintenance procedures.
Power cord maintenance
If the supply cord needs replacing, the task must be carried
out by the manufacturer, the manufacturer’s agent, or an
authorised service centre in order to avoid a safety hazard.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all
times.
2. Remove dust and dirt regularly. Cleaning is best done
with a soft brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
Caution. Do not use cleaning agents to clean the plastic
parts of the saw. A mild detergent on a damp cloth is
recommended.
General inspection
Regularly check that all the fixing screws are tight.
They may vibrate loose over time.
q
r
s
t