Filter
Top Products
7
• Before you switch on the machine, check that all
wrenches and adjustment tools have been removed.
• When you leave your workplace, switch off the motor
and pull out the power plug.
• All guards and safety devices have to be refitted
immediately after completion of any repairs or
maintenance.
• It is imperative to observe the accident prevention
regulations in force in your area as well as all other
generally recognised rules of safety.
• The machine may be used in closed room only in
conjunction with a suitable vacuum extraction system.
• This table saw must be connected to a 230–240V
socket-outlet with a minimum 10A circuit.
• Never use the cord for any purpose other than that for
which it is intended!
• Adopt a firm standing position and keep your balance at
all times.
• Check the tool for signs of damage!
• Before you use the tool it is imperative to check that
its safety devices and any slightly damaged parts are
working properly and in the way intended.
• Check that the moving parts work properly and do not
jam or whether any of the parts are damaged. All parts
must be fitted correctly and satisfy all conditions for the
tool to work properly.
• Unless otherwise stated in these instructions, damaged
safety devices and parts must be repaired or replaced by
an authorised service facility.
• Have damaged switches replaced by an authorised
service facility.
• This tool complies with the pertinent safety regulations.
Repairs are to be carried out only by qualified
electricians at authorised service centres, using original
replacement parts. The user may suffer an accident if
this condition is not observed.
• Rebating or grooving should not be carried out unless
suitable guarding, such as a tunnel guard, is fitted
above the table saw.
• Saws shall not be used for slotting (stopped groove).
Wear goggles • Wear earmuffs • Wear a breathing mask
Unpacking
Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is
missing. If you find anything wrong, do not operate the
tool until the parts have been replaced or the fault has
been rectified. Failure to do so could result in serious
personal injury.
1. Remove all loose parts from the carton.
2. Remove the packing materials from around the saw.
3. Carefully lift the saw from the carton and place it on a
level work surface.
Required Tools
The following tools (not supplied) are required to assemble
and maintain the table saw
• 18mm spanner
• 13mm spanner
• Phillips head screwdriver