Filter
Top Products
Repair
Repairing the
Advanced Display Module (ADM)
Replace the AD
M
To replace the Advanced Display Module, disconnect
the cable from the module and remove the module
from the bracket. Install the new module on the
bracket and attach the cable.
Figure 19 Replace the Advanced Display Module
Install Key Token or Upgrade Token
1. Shut off the PD2K power switch.
2. Remove the token access panel.
Fi
gure 20 Remove Token Access Panel
3. Remove blue ke
y token.
4. Insert and pr
ess black upgrade token (T) firmly
into slot.
NOTE: There i
s no preferred orientation of the
token.
Figure 21 Insert Token
5. Turn the power switch back on. The red indicator
light (L) will flash until the new firmware is
completely loaded.
6. Remove the token (T).
7. Replace the blue key token.
NOTE: The blue key token is required for proper
operation.
8. Replace the token access panel.
36 332709B