Filter
Top Products
G0640X 17" Wood/Metal Bandsaw
-11-
After all parts have been removed from the three
boxes, you should have the following items:
Main Components: (Figure
2 & 3) Qty
A. Bandsaw (not shown) ................................. 1
B. Table .......................................................... 1
C. Miter Gauge ................................................ 1
D. Fence Assembly ......................................... 1
E. Resaw Fence Attachment .......................... 1
F. Front Fence Rail ......................................... 1
G. Rear Fence Rail ......................................... 1
H. Handwheel (not shown) ............................. 1
I. V-Belt A27 (not shown) .............................. 1
J. Scale (not shown) ...................................... 1
Fasteners (and where used): Qty
Hex Bolt M8-1.25 x 100 (Positive Stop) ............
1
Hex Nut M8-1.25 (Positive Stop) .......................
1
Cap Screw M6-1 x 20 (Handwheel) ..................
1
Hex Bolts M8-1.25 x 16 (Table) ........................
4
Lock Washers 8mm (Table) ..............................
4
Flat Washers 8mm (Table) ................................
4
Cap Screws M6-1 x 25 (Rear Rail) ...................
2
Hex Bolts M6-1 x 20 (Front Rail) .......................
2
Lock Washers 6mm (Front Rail) .......................
2
Flat Washers 6mm (Front Rail) .........................
2
Hex Nut M8-1.25 (Fence Lock Lever) ...............
1
Hex Nut M6-1 (Rail Pad) ...................................
1
Flat Washer 8mm (Attachment Lock Handle) ...
1
Tools & Other Miscellaneous Items: Qty
Hex Wrench 5mm ..............................................
1
Hex Wrench 8mm ..............................................
1
Open End Wrench 10/13mm .............................
1
Table Pin ...........................................................
1
Table Insert .......................................................
1
Rail Pad M6-1 x 18 (attaches to fence) ............
1
Fence Lock Lever M8-1.25 x 22 .......................
1
Fence Attachment Lock Handle M8-1.25 x 44 ..
1
Fence Attachment T-Slot Nut ............................
1
Figure 2. Bandsaw components.
B
C
D
Figure 3. Fence components.
G
E
D
F
If any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them, or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss
-
ing.
Inventory