Filter
Top Products
G0526 6" Jointer -17-
V-Belt
Components and Hardware Needed: Qty
V-Belt A-54 ..................................................1
Tools Needed:
12mm Wrench or Socket ............................1
Straightedge ................................................1
To install the V-belt:
1. Remove the back access panel from the join-
ter stand.
2. Using a 12mm wrench, loosen the motor
mount bolts. Note—DO NOT completely
remove the motor mount bolts.
3. Slide the motor upward far enough to allow
the V-belt to be placed around the cutterhead
pulley and the motor pulley.
4. Carefully allow the motor to slide downward,
tensioning the V-belt with the weight of the
motor.
5. Using a straightedge, check the alignment of
the V-belt and the two pulleys (Figure 14).
— If the V-belt is aligned between the pul-
leys, continue on to step 7.
— If the V-belt is NOT aligned between the
pulleys, continue with the next step.
6. Adjust the motor until the V-belt is aligned
between the pulleys. Note—The pulleys can
also be adjusted in and out along the motor
shaft and cutterhead shaft by loosening the
pulley setscrews.
7. Tighten the motor mount bolts loosened in
step 1
Figure 14. The V-belt should be in alignment
with the two pulleys.