Filter
Top Products
-20-
G0526 6" Jointer
Pedestal Switch
Components and Hardware Needed: Qty
Pedestal Switch ..........................................1
Hex Bolts
5
⁄16"-18 x 1" ..................................4
Hex Nuts
5
⁄16"-18 ........................................4
Flat Washers
5
⁄16" ........................................8
Tools Needed:
12mm Wrench or Socket ............................2
To install the pedestal switch:
Using two 12mm wrenches, secure the pedestal
switch to the jointer stand with the hex bolts, the
flat washers, and the hex nuts (Figure 19).
Figure 19. Correctly installed pedestal switch.
Components and Hardware Needed: Qty
Handwheels ................................................2
Handwheel Handles ....................................2
Tools Needed:
Phillips Head Screwdriver............................1
14mm Wrench..............................................1
To install the handwheels:
1. Using a 14mm wrench, secure the hand-
wheel handles to the handwheels (Figure
20).
2. Using a Phillips head screwdriver, remove
the two Phillips head screws and flat wash-
ers from the end of the leadscrews under
each table.
3. Secure the handwheel assemblies to the end
of the leadscrews with the Phillips head
screws and flat washers that were removed
in step 2.
Figure 20. Securing the handwheel handle.
Handwheels