Filter
Top Products
G0526 6" Jointer -19-
Components and Hardware Needed: Qty
Cutterhead Guard ........................................1
Tools Needed:
2.5mm Allen Wrench....................................1
To install the cutterhead guard:
1. Slide the cutterhead guard shaft down
through the mounting hole on the table.
Note—The guard may not fully seat in the
hole initially; however, rotating the guard will
allow the shaft to fully seat in the hole.
2. Using a 2.5mm Allen wrench, thread the
setscrew through the hole in the forked end
of the cutterhead guard shaft (Figure 17).
Note—Thread the setscrew far enough to
prevent the guard from being pulled out.
Components and Hardware Needed: Qty
V-Belt Guard ................................................1
Hex Bolt
5
⁄16"-18 x 2
1
⁄2"..................................1
Flat Washer
5
⁄16" ..........................................1
Tools Needed:
12mm Wrench or Socket ............................1
To install the V-belt guard:
Using a 12mm wrench, secure the V-belt guard
over the cutterhead pulley and V-belt with the hex
bolt and flat washer (Figure 18).
Figure 17. Cutterhead guard setscrew.
Figure 18. Correctly installed V-belt guard.
V-Belt Guard
V-Belt GuardCutterhead Guard
NOTICE
The cutterhead guard must always return to
the closed position whenever it is moved.
Repeat steps 1-3 until this occurs.
3. Raise the fence and rotate the guard one
revolution counter-clockwise as it appears
from the top. Hold the guard in position.
4. Lower the fence and allow the guard to swing
back against the fence.