Filter
Top Products
G0526 6" Jointer -5-
No list of safety guidelines can be complete.
Every shop environment is different. Always
consider safety first, as it applies to your
individual working conditions. Use this and
other machinery with caution and respect.
Failure to do so could result in serious per-
sonal injury, damage to equipment, or poor
work results.
Like all machines there is danger associated
with the Model G0526. Accidents are fre-
quently caused by lack of familiarity or fail-
ure to pay attention. Use this machine with
respect and caution to lessen the possibility
of operator injury. If normal safety precau-
tions are overlooked or ignored, serious
personal injury may occur.
Additional Safety Instructions For Jointers
1. JOINTING SAFETY BEGINS with your
lumber. Inspect your stock carefully before
you feed it over the cutterhead. If you have
any doubts about the stability or structural
integrity of your stock, DO NOT JOINT IT!
2. MAINTAIN PROPER RELATIONSHIPS of
infeed and outfeed table surfaces and cut-
terhead knife path.
3. ALWAYS USE A PUSH PADDLE when
jointing. Never place your hands directly
over the cutterhead.
4. SUPPORT THE WORKPIECE adequately
at all times during operation, and maintain
control over the work at all times.
5. WHEN JOINTING, DO NOT stand directly
at the end of either table. Position yourself
just to the side of the infeed table to protect
yourself from possible kickbacks.
6. NEVER MAKE JOINTING CUTS deeper
than
1
⁄8".
7. NEVER JOINT A BOARD that has loose
knots. All defects should be cut out of the
board before it is planed or jointed.
8. NEVER JOINT end grain.
9. JOINT WITH THE GRAIN. Jointing against
the grain is dangerous and could produce
chatter or excessive chip out, which could
lead to loss of control over the workpiece.
10. WITH THE EXCEPTION OF RABBETING,
all operations must be performed with the
guard in place. After rabbeting, be sure to
replace the guard.
11. NEVER BACK THE WORK toward the
infeed table. If a cut must be interrupted, lift
the workpiece clear of the cutterhead.
12. HABITS — GOOD AND BAD — are hard
to break. Develop good habits in your shop
and safety will become second-nature to
you.
13. “KICKBACK” is when the workpiece is
thrown off the jointer table by the force of
the cutterhead. Always use push paddles
and safety glasses to reduce the likelihood
of injury from “kickback.” If you do not
understand what kickback is, or how it
occurs, DO NOT operate this machine.
14. PROLONGED EXPOSURE TO WOOD
DUST IS KNOWN TO CAUSE CANCER IN
HUMANS. Always wear an OSHA-
approved respirator when working in an
environment that could contain wood dust.