Filter
Top Products
-16-
G0524 Rip Saw
To remove the saw base unit from the crate
pallet:
1. Cut off and remove all plastic straps from the
crate.
2. Using a forklift, position the saw over the final
location.
3. Place the cast iron feet under the leveling
screws.
4. Lower the saw onto the cast iron feet as
shown in Figure 13
.
Figure 13. Cast iron feet.
5. Adjust the leveling screws until the saw table
is level.
The Model G0524 is a
heavy machine that
weighs approximately
1980 lbs. Serious per
-
sonal injury may occur
if safe moving methods
are not followed. Use
the assistance of power
equipment when moving
the crate and placing the
machine.
Cast Iron Foot
(1 of 4)
Leveling Screw
(1 of 4)
Placement
To connect the power cord to the saw:
1. Read through Section 3: Circuit Requirements
to double-check that your setup follows the
safety and circuit requirements, and that
the power cord you use meets the minimum
requirements for this machine.
2. Open the electrical panel box.
3. Feed the power cord through the strain
relief on the side of the electrical panel, and
connect the cord wires to the main terminal
(Figure 14).
Figure 14. Main terminal located inside saw
electrical panel.
4. Close the electrical panel door.
5. DO NOT connect the power cord to the
power source at this time.
Power Cord