Filter
Top Products
-30-
G0524 Rip Saw
The pressure rollers must all be the same dis-
tance away from the table surface (conveyor
track).
To adjust the pressure rollers:
1. Disconnect the saw from the power
source!
2. Using the blade height handwheel, raise the
bottom edge of the blade above the bottom-
dead-center of the pressure rollers.
3. Using the pressure roller height handwheel,
raise the head of the saw high enough to
allow a flat board to be placed under all the
the pressure rollers
.
4. Slowly lower the head.
— If the pressure rollers make contact with
the board at the same time, they are
adjusted correctly.
— If the pressure rollers do not make con
-
tact with the board at the same time, they
need to be adjusted so they do. Continue
with the next step.
5. Each pressure roller can be independently
adjusted by loosening the jam nut and turn
-
ing the small setscrew (Figure 32). Note—
Turning the setscrew clockwise, as viewed
from the top, lowers the pressure roller;
counterclockwise raises the pressure roller.
6. Once the pressure rollers are adjusted cor-
rectly, retighten the jam nuts.
Figure 32. Setscrew for height adjustment.
Setscrew
Jam Nut
Pressure Rollers