Filter
Top Products
G0524 Rip Saw -19-
Components and Hardware Needed: Qty
Auxiliary Roller Brackets (Left) ....................
2
Auxiliary Roller Brackets (Right) .................
2
Auxiliary Rollers ...........................................
4
Hardware Bag
—Cap Screws M6-1.0 x 16 ..................8
—Setscrews M6-1.0 x 30 .....................
4
—Lock Washers 6mm ..........................
8
—Flat Washers 6mm ...........................
4
—Hex Nuts 6-1.0 ..................................
4
Tools Needed:
Allen Wrench 3mm ......................................
1
Allen Wrench 4mm ......................................
1
Allen Wrench 5mm ......................................
1
Wrench 10mm .............................................
1
Wrench 13mm .............................................
1
The Model G0524 is supplied with 4 auxiliary
rollers (Figure 17) that can be attached when rip
cutting workpieces shorter than 8". Note—
These
auxiliary rollers can be left on the machine when
cutting longer boards; however, the maximum
thickness cutting capacity of the saw is reduced
to 2
1
⁄4".
Figure 16. Dust collection hook-up.
An efficient and clean dust collection system is
essential to the proper function of the rip saw.
Ensuring a healthy work environment is also
dependent upon cleaning and maintaining the
dust collection system. Clamp a 4" hose from the
dust collection system to the dust port (Figure
16).
Figure 17. Auxiliary roller (1 of 4).
Auxiliary Roller
Auxiliary RollersDust Collection