Filter
Top Products
-24-
G0524 Rip Saw
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person
-
al injury.
Check for the following conditions before
each use:
• Loose mounting bolts.
• Damaged saw blade.
• Worn or damaged wires.
• Leaking or broken lube lines.
• Empty lube reservoir.
• Any other condition that could hamper the
safe operation of this machine.
Monthly:
• Grease Fittings
• V-belts
After the first 100 hours:
• Gear Box
Every 2500 Hours:
• Gear Box
Lubricate the four grease fittings (Figure 24) with
a general purpose grease after every month (160
Hours) of regular use.
Figure 24. Grease fittings (Additional 2 fittings
are on opposite side of head casting).
The oil inside the gear reducer should be replaced
after the first month (160 hours) of regular use.
We recommend 90 Wt. gear oil.
After the first oil change, the oil inside the gear
reducer should be replaced after every 2500
hours of use. We recommend 90 Wt. gear oil.
Grease Fittings
(2 of 4)
Gear Box
Grease Fittings
Schedule
SECTION 7: MAINTENANCE