Filter
Top Products
-20-
G0524 Rip Saw
To install the auxiliary rollers:
1. Using a 13mm wrench, remove the 4 hex
nuts from the setscrews on the underside of
the head casting (Figure 18
).
3. Slide the 4 auxiliary roller brackets over the
setscrews and secure them with the four M6-
1.0 hex nuts and 6mm flat washers, as well
as the 4 hex nuts removed in step 1
(Figure
20).
4. Using a 5mm Allen wrench, secure the 4
auxiliary rollers to the brackets with the 8 cap
screws and lock washers (Figure 21
).
2. Using a 3mm Allen wrench, remove the four
M6-1.0 x 10 setscrews from the bottom edge
of the head casting and replace with the four
M6-1.0 x 30 setscrews (Figure 19). Note—
The head of the M6-1.0 x 10 setscrews will
be recessed up in the head casting.
Figure 18. Hex nut.
Hex
Nut and
Setscrew
(1 of 4)
Figure 19. Setscrew.
Setscrew (1 of 4)
Note—Will be recessed
Figure 21. Auxiliary roller
mounting configuration.
Cap Screws &
Lock Washers
Figure 20. Auxiliary roller bracket.
Auxiliary Roller
Bracket
Hex Nut
(Step 1)
M6-1.0 Hex Nut &
6mm Flat Washer