Filter
Top Products
G0555 14" Ultimate Bandsaw -9-
Piece Inventory
After you remove the items from Box 1, you
should have:
QTY
Bandsaw Unit..............................................1
Table ..........................................................1
Trunnion Support ........................................1
Stand Top ..................................................1
Stand Top Braces ......................................2
Stand Sides ................................................2
Lower Stand Braces....................................2
Upper Stand Braces....................................2
Knobs..........................................................2
Miter Gauge ................................................1
Hardware Bags:
— Hex Bolt M8-1.25 x 35 ....................4
— Flat Washer 8MM............................8
— Lock Washer 8MM ..........................6
— Hex Nut M8-1.25 ............................5
— Hex Bolt M8-1.25 x 30 ....................2
— Hex Bolt M8-1.25 x 80 ....................1
— Carriage Bolt M8-1.25 x 16 ............8
— Flange Nut M8-1.25 ........................8
— Hex Bolt M6-1.0 x 16 ....................16
— Flat Washer 6MM..........................16
— Flange Nut M6-1.0 ........................16
— Stand Foot ......................................4
— Hex Nut
3
⁄8"-16 ................................8
— Flat Washer M10 ............................8
Figures 4 and 5 on the next page show the items
from Box 1.
Unpacking
The Model G0555 Bandsaw is shipped from the
manufacturer in 2 carefully packed cartons. If you
discover the machine is damaged after you have
signed for delivery, please call Customer Service
immediately for advice.
Save the containers and all packing materials for
possible inspection by the carrier or its agent.
Otherwise filing a freight claim can be difficult.
When you are completely satisfied with the con-
dition of your shipment, you should inventory its
parts.
The Model G0555 weighs
approximately 167 lbs.
when fully assembled.
DO NOT over-exert your-
self while unpacking or
moving your machine –
get assistance.
Some metal parts may
have sharp edges that
can cause minor injury.
Please examine the
edges of all metal parts
BEFORE handling them
and be careful WHILE
handling them.
SECTION 5: SET UP