Filter
Top Products
G0555 14" Ultimate Bandsaw -21-
6. Tighten the assembly lock bolt.
7. Loosen the thumbscrew on the support bear-
ing adjustment shaft.
8. Use the knurled knob to position the support
bearing approximately .016" away from the
back of the blade as illustrated in Figure 22.
Figure 23. Dollar bill folded twice to make a
quick .016" gauge.
5. Look at the face of the support bearing and
rotate the blade guide assembly side-to-side,
until the blade is perpendicular with the face
of the support bearing as illustrated in Figure
21.
Figure 21. Blade should be perpendicular (90˚)
to the face of the support bearing.
.016''
Figure 22. Blade should be aligned approxi-
mately .016" away from the bearing edge.
9. For a quick gauge, fold a dollar bill in half
twice (four thicknesses of a dollar bill is
approximately .016") and place it between
the support bearing and the blade as shown
in Figure 23.
10. Tighten the thumbscrew to keep the support
bearing locked in place.
NOTICE
Whenever changing a blade or adjusting ten-
sion and tracking, the upper and lower blade
support bearings and guide-blocks must be
properly adjusted before cutting operations.
Bandsaw
Blade
Support
Bearing