Filter
Top Products
-16- G0555 14" Ultimate Bandsaw
Installing Table
To install the table on the bandsaw:
1. Remove the aluminum table insert from the
center of the table and remove the table pin
from the end of the table slot.
2. Line up the blade with the table slot and pass
the table around the blade until the blade is
in the center of the table, then turn the table
90˚ counterclockwise and rest the table trun-
nions on the trunnion base. The trunnion
bolts should be hanging out of the bottom of
the trunnion base at this point.
3. Locate the two knobs from the hardware bag
and thread them onto the trunnion bolts that
hang out through the bottom of the trunnion
base as illustrated in Figure 16.
Figure 16. Secure table to trunnion with knobs
from hardware bag.
Installing
Positive Stop
To install the positive stop:
1. Locate the M8-1.0 x 80 hex bolt (this is the
positive stop bolt) from the hardware bag and
thread on the remaining M8-1.0 hex nut from
the hardware bag.
2. Thread the positive stop bolt into the band-
saw into the trunnion base so that it is
installed similar to Figure 15. The positive
stop depth will be set after the table has been
installed.
Figure 15. Shows positive stop bolt installed.
Positive
Stop
Bolt
4. Place the table insert in the center of the
table, so that it sits flush with the table top
surface.
5. Insert the pin into the end of the table slot.