Filter
Top Products
G0555 14" Ultimate Bandsaw -17-
Installing Fence
To install the fence:
1. Fasten the large rail to the front of the band-
saw table with the (2) M6-0.8 x 20 hex bolts,
(2) 6mm lock washers, and (2) 6mm flat
washers from the hardware bag as shown in
Figure 17.
Figure 17. Fastening large rail to table.
Figure 18. Installing fence onto rails.
2. Fasten the small rail to the back of the band-
saw with the (2) M6-0.8 x 16 cap screws from
the hardware bag.
3. Thread the M8-1.0 hex nut from the hard-
ware bag onto the fence handle threads,
then thread the fence handle into the fence.
6. Push the fence handle down to lock the
fence in position.
4. Tighten the hex nut (already on the fence
handle threads) down to the fence body to
keep the fence handle from rotating.
5. Pull the fence handle up and place the fence
on the large rail as shown in Figure 18.