Filter
Top Products
-6- G0555 14" Ultimate Bandsaw
SECTION 3: CIRCUIT REQUIREMENTS
110V Operation
The Model G0555 motor is prewired to operate at
110V, and includes a plug (similar to the illustra-
tion in Figure 1) that has a ground prong and two
current carrying prongs. The plug should only be
placed into a grounded outlet box similar to the
one illustrated in Figure 1. Make sure the outlet
that you plug into is properly installed and
grounded in accordance with all local codes and
ordinances.
Figure 1. Typical 110V 3-prong plug and outlet.
Under normal 110V use, the motor draws approx-
imately 10 amps. We recommend a 15 amp cir-
cuit breaker or a 15 amp slow-blow fuse.
We also recommend that the circuit you use
should be dedicated, (i.e., the G0555 should pro-
vide the only draw from that circuit). If frequent
circuit failures occur when using the bandsaw,
contact our Service Department or your local
electrical contractor.
220V Operation
The Model G0555 motor can be wired to single-
phase 220V. Under normal use, the motor draws
approximately 5 amps at 220V. We recommend a
10 amp circuit breaker for 220V operation. This
should be satisfactory for normal use while pro-
viding enough protection for the circuits. Also, be
sure the wires in your circuit are rated for at least
10 amp service.
This machine does not come supplied with a
220V plug, therefore a suitable 220V plug must
be wired in. When operating at 220V, we recom-
mend using a NEMA-style 6-15 plug and outlet.
See Figure 1A. You may also “hard-wire” the
machine directly to your panel, provided you
place a disconnect switch near the machine.
Check the electrical codes in your area for
specifics on wiring requirements.
Figure 1A. NEMA 6-15 220V plug and outlet.