Filter
Top Products
G0555X 14" Extreme Series Bandsaw
-11-
After all the parts have been removed from the
two boxes, you should have the following items:
Main Components: (Figure
2) Qty
A. Stand .......................................................... 1
B. Bandsaw Unit ............................................. 1
C. Trunnion Base ............................................ 1
D. Lever Board ................................................ 1
E. Miter Gauge ................................................ 1
F. Extension Table .......................................... 1
G. Main Table .................................................. 1
H. Fence Assembly ......................................... 1
I. Resaw Fence ............................................. 1
J. Front Fence Rail ......................................... 1
K. Rear Fence Rail ......................................... 1
Fasteners and Tools: (not shown) Qty
• Rubber Feet (Stand) ..................................
4
• Hex Nuts
3
⁄8-16 (Feet/Stand) ...................... 8
• Flat Washers 10mm (Feet/Stand) ..............
8
• Hex Bolts M8-1.25 x 35 (Bandsaw/Stand) .
4
• Flat Washers 8mm (Bandsaw/Stand) ........
8
• Lock Washers 8mm (Bandsaw/Stand) .......
4
• Hex Nuts M8-1.25 (Bandsaw/Stand) ..........
4
• Hex Bolts M8-1.25 x 30 (Trunnion Base) ...
2
• Lock Washers 8mm (Trunnion Base) ........
2
• Hex Bolt M8-1.25 x 80 (Positive Stop) .......
1
• Hex Nut M8-1.25 (Positive Stop) ...............
1
• Spacers (Lever Board) ...............................
4
• Cap Screws M8-1.25 x 60 (Lever Board) ..
4
• Hex Nuts M8-1.25 (Lever Board) ...............
4
• Set Screws M8-1.25 x 20 (Lever Board) ....
4
• Cap Screws M6-1 x 25 (Lever Board) .......
4
• Lock Washers 6mm (Lever Board) ............
4
• Flat Washers 6mm (Lever Board) ..............
4
• Knobs M10-1.5 (Table) ..............................
2
• Hex Bolts M6-1 x 20 (Front Rail) ...............
2
• Flat Washers 6mm (Front Rail) ..................
2
• Lock Washers 6mm (Front Rail) ................
2
• Cap Screws M6-1 x 16 (Rear Rails) ..........
2
• Lock Handle M8-1.25 x 20 (Fence) ............
1
• Hex Nut M8-1.25 (Fence) ...........................
1
• Moving Plate (Resaw) ................................
1
• Lock Handle M8-1.25 x 44 (Resaw) ...........
1
• Flat Washer 8mm (Resaw) ........................
1
• Hex Wrenches 3, 4, 5mm .................1 Each
If any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them, or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss
-
ing.
Inventory
A
B
C
D
E
F
G
H
I
J
K
Figure 2. Main components inventory.