Filter
Top Products
G0555X 14" Extreme Series Bandsaw
-15-
12. Remove the aluminum table insert from the
center of the table and remove the table pin
from the end of the table slot.
13. Fit the table around the blade and rest the
table trunnions on the trunnion base, making
sure the trunnion bolts are hanging out of the
bottom of the trunnion base.
14. Thread the two M10-1.5 knobs onto the trun-
nion bolts hanging through the bottom of the
trunnion base, as illustrated in
Figure 12.
Figure 12. Table installation on trunnion base.
15. Place the table insert in the center of the
table, so it sits flush with the table top sur
-
face.
16. Insert the pin into the end of the table slot.
9. Attach the lever board to the bandsaw body
with the four spacers and four M8-1.25 x 60
cap screws, as shown in
Figure 9.
Figure 9. Lever body attached.
10. Thread the four set screws into the lever
board from underneath until they are flush
with the top of the lever board (
Figure 10).
Figure 10. Set screws installed in lever board.
11. Attach the extension table to the lever board
with the four M6-1 x 25 cap screws, four 6mm
flat washers, and four 6mm lock washers
(Figure 11). Only thread the cap screws in
halfway for now (adjustments to the exten
-
sion table will be made later).
Figure 11. Extension table installed.