Grizzly G0602 Lathe User Manual


  Open as PDF
of 64
 
BdYZa<%+%'B[\#H^cXZ.$%-
"'("
I]Z [VXZeaViZ XVc WZ jhZY id ijgc cdc"Xna^cYg^"
XVaeVgihdg[dgd[["XZciZgijgc^c\WnXaVbe^c\i]Z
ldg`e^ZXZidi]Z[VXZeaViZ#
GZ[Zgidi]ZMounting Chuck or Faceplateegd"
XZYjgZhdcPage 20idbdjcii]Z[VXZeaViZ#
To load a workpiece onto the faceplate:
1. 9>H8DCC:8IEDL:GIDI=:A6I=:
2# Hjeedgii]Zldg`e^ZXZ#
3. Ha^YZi]ZiV^ahidX`idi]Zldg`e^ZXZ#
4. AdX`i]ZiV^ahidX`VcYi]Zcijgci]ZiV^ahidX`
fj^aahd i]ZYZVY XZciZgbV`ZhXdciVXi l^i]
i]ZXZciZged^cid[ndjgldg`e^ZXZ#
5. AdX` i]ZiV^ahidX` fj^aal]Zc hj[[^X^ZciegZh"
hjgZ ^h Veea^ZY id ]daY i]Z ldg`e^ZXZ ^c
eaVXZ#
Note: Depending on the workpiece, some
additional support may be needed.
6. HZXjgZ i]Z ldg`e^ZXZ l^i] V b^c^bjb d[
i]gZZ^cYZeZcYZciXaVbe^c\YZk^XZh#;V^ajgZ
id[daadl i]^hhiZe bVnaZVY idYZVYan ^c_jgn
idndjghZa[dgWnhiVcYZgh#IV`Z^cidVXXdjci
gdiVi^dcVcYi]ZXjii^c\[dgXZhVeea^ZYidi]Z
ldg`e^ZXZ l]Zc XaVbe^c\ id i]Z [VXZeaViZ#
Make sure your clamping application will
not fail!
7. JhZ V adlZg GEB l]Zc bVX]^c^c\ ]ZVkn
ZXXZcig^Xldg`e^ZXZh#
Figure 17.;VXZeaViZ^chiVaaZY#
Faceplate
Use a lower RPM when machin-
ing heavy eccentric workpieces;
securely clamp your workpiece
and remove the chuck key!
Objects thrown from a lathe can
cause serious injury or death to
the operator or bystanders.
Use a minimum of three independent
clamping devices when turning eccentric
workpieces. Failure to provide adequate
clamping will cause workpiece to eject.
 previous next