Grizzly G0602 Lathe User Manual


  Open as PDF
of 64
 
BdYZa<%+%'B[\#H^cXZ.$%-
"'*"
To setup the tailstock to cut tapers:
1. AddhZci]ZiV^ahidX`adX`cji#
2. Jh^c\V)bb]ZmlgZcX]!VaiZgcViZanaddhZc
VcY i^\]iZc i]Z aZ[i VcY g^\]i d[[hZi VY_jhi"
bZci hZi hXgZlh jci^a i]Z YZh^gZY d[[hZi ^h
^cY^XViZYdci]ZhXVaZhZZFigure 19#
3. I^\]iZci]ZiV^ahidX`adX`cji#
Note: To return the tailstock back to the
original position, repeat the process until the
centered position is indicated on the scale.
I]Z iV^ahidX` ^h [VXidgn Va^\cZY l^i] i]Z ]ZVY"
hidX`# LZ gZXdbbZcY i]Vi ndj iV`Zi]Z i^bZ id
ZchjgZ i]Vi i]Z iV^ahidX` ^h Va^\cZY id ndjg dlc
YZh^gZYidaZgVcXZh#
To align the tailstock:
1. Jh^c\ V egZX^h^dc aZkZa dc i]Z WZYlVnh!
bV`ZhjgZi]ZaVi]Z^haZkZah^YZ"id"h^YZVcY
[gdci"id"WVX`#>[i]ZaVi]Z^hcdiaZkZa!XdggZXi
i]^hXdcY^i^dcWZ[dgZegdXZZY^c\#
2. <Ziilde^ZXZhd[hiZZagdjcYhidX`i]ViVgZ
ild^cX]Zh^cY^VbZiZgVcYh^m^cX]Zhadc\#
3. 8ZciZg Yg^aa Wdi] ZcYh d[ dcZ e^ZXZ d[ i]Z
gdjcYhidX`#HZi^iVh^YZ[dgjhZ^cStep 6.
4. Jh^c\i]Zdi]Zge^ZXZd[hidX`!bV`ZVYZVY
XZciZgWnijgc^c\Vh]djaYZgidbV`ZVh]Vc`#
;a^ei]Ze^ZXZdkZg^ci]ZX]jX`VcYijgcV+%§
ed^cihZZFigure 20.
Note:As long as the dead center remains in
the chuck, the point of your center will remain
true to the spindle axis. Keep in mind that the
point will have to be refinished whenever it is
removed and returned to the chuck.
Figure 20.8]jX`XZciZg^c\i]ZYZVYXZciZg#
Aligning TailstockCutting Shallow
Ta p e r s w i t h Ta i l s t o c k
Figure 19.AZ[id[[hZiVY_jhibZci#
AZ[iD[[hZi
6Y_jhibZcih
D[[hZiHXVaZ
IV^ahidX`
AdX`Cji
 previous next